







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ES Windows Fence Installation: The San Antonio Owner’s Guide
ES Windows fence installation in San Antonio typically runs $3,500 to $9,000 installed, depending on the fence line length, post spacing, and whether we’re replacing a failed section or running an entirely new perimeter. We stock ES Windows-compatible fence hardware and panels on our trucks, so most swaps are a one-visit job. The way most San Antonio homeowners find us is the same story: a summer storm or a few years of Texas heat finally did in the old fence, and now it’s leaning, popping fasteners, or cracking at the rails.

What makes ES Windows fencing different is the extrusion profile. The aluminum or steel channels are narrower than the big-box generic stuff, which means off-the-shelf posts and brackets often don’t seat correctly. If you’ve got ES Windows-brand fencing, you already know it was built to a specific spec, and the replacement parts need to match that spec, not just be “close enough.”
Which ES Windows Models This Applies To

The ES Windows fence line runs on a modular track system, and the compatibility gotcha is the track depth. Earlier ES Windows fence series used a 1.25-inch channel, while the newer series moved to a 1.5-inch channel. The panels are not interchangeable between the two, and forcing a 1.25-inch panel into a 1.5-inch track leaves slop that turns into rattle, then wobble, then a fence section that drops during the first real north wind.
To identify what you have, look at the bottom rail of any fence section. ES Windows stamps the series code there: the letter prefix tells you the generation, and the three-digit number is the panel height in millimeters. If the stamp is worn off, we measure the channel width on-site, which takes about thirty seconds. On the OEM-versus-aftermarket decision: for ES Windows specifically, we’ve found the OEM brackets and post caps hold better over time because they’re anodized to match the original finish. Aftermarket parts work, but the finish fades differently in San Antonio UV, and a year later you can spot which sections were replaced. We’ll always give you both options with honest prices, and let you decide.
Styles & brands we work with







Signs Your ES Windows Fence Installation Is Failing
- Leaning posts at the corners or gate hinge. This is almost always a base plate issue. The galvanized base plate corrodes faster in San Antonio’s clay soil, especially if sprinkler overspray hits it daily. The post itself is usually fine; the connection to the footing is what gave out.
- Panels rattling or chattering in the wind. ES Windows tracks use a spring clip system that loses tension over time, particularly with repeated thermal expansion. The clips are cheap; ignoring the rattle until the panel works loose is not.
- Discolored or chalky rails. That’s the anodized finish breaking down under Texas sun. It’s cosmetic at first, but once the oxide layer is compromised, the aluminum underneath starts to pit. Sealing only buys a few months. Replacement is the honest fix.
- Gate dragging or not latching. The hinge side has settled, usually because the base plate was installed on unstabilized soil. San Antonio’s clay expands and contracts enough through the year to shift a post a half-inch, which at the gate means a latch that misses by a mile.
- Fasteners popping or sheared heads. ES Windows uses stainless hardware, but overtightened or mismatched screws from a previous repair can snap under load. If you see a sheared head on a rail bracket, the panel is carrying weight it wasn’t designed for, and the next rain that softens the ground is when it lets go.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In San Antonio, expect $3,500 to $9,000 for a full ES Windows fence installation. The low end is a straight run under 40 linear feet with existing footings in decent shape. The high end is a longer perimeter, corner posts that need new footings, a gate rebuild, or demo and haul-off of the old fence. Every quote from Sawyer Remodel San Antonio is a written, line-item price before any work starts. You’ll see the cost of panels, posts, hardware, labor, and disposal broken out. The number on the invoice is the number you approved.
We use manufacturer-backed materials and stand behind the install with our 365-Day Done Right Promise. If something isn’t right within a year, we make it right, in writing, on every job. That applies to the gate swinging true, the panels seated correctly, and the post caps staying where they belong. The craft comes first. Everything else follows.
DIY or Call Us?
You can absolutely check a few things before calling: look for the series stamp on the bottom rail, check whether posts are plumb with a simple level, and note which sections are affected. Knowing whether the failure is at the post, at the rail, or at the panel saves time on the estimate.
What we don’t recommend is pulling panels out of a damaged track yourself. ES Windows panels are heavy, and the spring clips are under tension. When a clip releases, it releases fast, and a dropped panel is not something you want landing on your hand or your patio. If a post has shifted in the footing, you’re dealing with concrete work and proper slope for drainage, not just swapping a couple of brackets. That’s where most DIY repairs in San Antonio go sideways: the fix looks right for one season, then the next summer’s heat reveals the mistake. Call (432) 547-6806 and we’ll come out, measure it, and give you a written price. The estimate is free.
FAQs

With proper install and the factory finish intact, an ES Windows fence in San Antonio lasts 15 to 20 years. The finish breaks down faster if sprinklers hit it daily or if it’s under heavy tree canopy, but the aluminum itself is not going to rot like wood or rust through like cheap steel.
Usually yes. If the post itself isn’t cracked, we can reset it in a new footing with proper drainage and it’ll be straight for years. Replacement is only necessary when the post is bent, cracked at the base, or the base plate has corroded beyond saving.
Most straight runs go in one day. A full perimeter with gates, new footings, and demo of the old fence takes two to three days. We’ll give you a timeline in the written quote before work starts, and you’ll know exactly when the crew is arriving under The Relay Visibility Guarantee.
We stock common ES Windows-compatible panels, brackets, base plates, and post caps on our trucks. If you need a specific series match we don’t have on hand, we order it direct and coordinate the install around delivery. Either way, you’re not chasing parts. That’s our job.
If you’re dealing with a failed ES Windows fence in San Antonio and you want a straight answer on what it costs to fix, call (432) 547-6806. We’ll give you a written price, a real arrival time, and a crew you’ll recognize when they show up. Sawyer Remodel San Antonio is an independent service provider and is not affiliated with ES Windows. We also stock parts for KraftMaid, Cambria, and Silestone projects.
Written by Luca Romano, Owner, Sawyer Remodel San Antonio at Sawyer Remodel San Antonio, serving San Antonio and nearby areas.


